prodmod.com:
01- Unscrew Switch Cover
prodmod.com:
02 - Drill out plastic welds
prodmod.com:
02b - Drill out plastic welds
prodmod.com:
03a - remove entire switch cover
prodmod.com:
03b - battery holder without switch cover
prodmod.com:
04 - Remove positive metal tab with red wire
prodmod.com:
05 - Pull tab and positive red wire out of holder
prodmod.com:
06 - Remove negative and positive tab pair
prodmod.com:
07 - Remove Spring from tab
prodmod.com:
08 - solder end of red wire where the spring was
prodmod.com:
09 - Test fit the metal tab back where you got it from
prodmod.com:
10a - Visualize where the LED and heat sink would fit
prodmod.com:
10b - Position set screw to visualize space
prodmod.com:
10c - Position set screw to visualize space
prodmod.com:
11 - Carefully remove negative tab and switch
prodmod.com:
12 - De-Solder switch away from spring tab
prodmod.com:
13 - visualize the new 3-position switch and spring tab
prodmod.com:
14 - flatten out the surface under the switch
prodmod.com:
15 - Test fit the switch - note the orientation
prodmod.com:
16 - Note the hole on the other side of the switch is not long enough
prodmod.com:
17 - extend this slot to the right
prodmod.com:
18 - extended switch lever slot
prodmod.com:
19 - When inserting the switch push only on the metal casing!!
prodmod.com:
20 - For Alkaline Batteries twist the two 1.2 ohm resistors together
prodmod.com:
21 - Position the two resistors
prodmod.com:
22 - Connect resistors together at one end
prodmod.com:
23 - cut black wires to size
prodmod.com:
24 - Strip a short amount off the end of the wire
prodmod.com:
25 - pre-tin the pins of the switch
prodmod.com:
26 - Hold switch steady while you solder the first wire
