David Reeves:
Heatpump 'Morse'
David Reeves:
Add case and ribbon
David Reeves:
program chip
David Reeves:
add more solder to battery holder pads to secure, then insert battery
David Reeves:
tin back pads with solder then place battery bracket
David Reeves:
battery bracket
David Reeves:
turn on overhead heat and melt solder - push around with pliers (still HOT!)
David Reeves:
Use pliers to move PCB carefully to HOT white ceramic and preheat a minute or two
David Reeves:
All components placed
David Reeves:
Add LEDs, cathode (short green line underneath always points to top of heart)
David Reeves:
LEDs, bottom (L) and top (R)
David Reeves:
place modified button on 2 pads
David Reeves:
Bend two legs up, squeeze the remaining ones together a bit to match pads
David Reeves:
Add ATTiny85
David Reeves:
ATTiny85
David Reeves:
add capacitor, 1K resistor and MOSFET
David Reeves:
P channel MOSFET
David Reeves:
1K resistor
David Reeves:
Capacitor
David Reeves:
pick up 5 3R0 resistors with tweezers
David Reeves:
3R0 resistor
David Reeves:
pads covered with solder paste
David Reeves:
solder paste scraped on screen
David Reeves:
solder paste added
David Reeves:
solder paste
David Reeves:
Alignment of PCB on screen
David Reeves:
stencil
David Reeves:
Unpopulated PCB (back)
David Reeves:
Unpopulated PCB (front)
David Reeves:
Kit Contents