Christian Liljedahl:
charlotte-dohm
Christian Liljedahl:
Koga Bike Light
Christian Liljedahl:
Slide to open
Christian Liljedahl:
Open
Christian Liljedahl:
Button shows clear signs of corrosion
Christian Liljedahl:
Power terminals corroded
Christian Liljedahl:
More corrosion on other side of pcb
Christian Liljedahl:
No wonder this light does not work
Christian Liljedahl:
LEDs in the ice
Christian Liljedahl:
Glaced with ice
Christian Liljedahl:
Refilling with Extra Virgin Olive Oil
Christian Liljedahl:
Oily ULN-driver
Christian Liljedahl:
Arduino board is alive and happy.
Christian Liljedahl:
No corrosion whatsoever.
Christian Liljedahl:
Some oil has drained, but no water has damaged the electronics
Christian Liljedahl:
Metropolis, illutron, light and ice
Christian Liljedahl:
Reflections in the ice
Christian Liljedahl:
Tire with rope in
Christian Liljedahl:
Rope through
Christian Liljedahl:
Tie a not on the ends
Christian Liljedahl:
thread the other end
Christian Liljedahl:
Another hole
Christian Liljedahl:
Surface must have a hole for the needle to go in
Christian Liljedahl:
hammering the next hole
Christian Liljedahl:
First end is threaded through
Christian Liljedahl:
Pull out the needle
Christian Liljedahl:
Pull out the needle
Christian Liljedahl:
Feed a bit of rope into the pipe
Christian Liljedahl:
Rope goes into the steel pipe
Christian Liljedahl:
Needle is through the tyre
