©
W1N9Zr0: 3D printed gems
©
W1N9Zr0: 3D printed gems
©
W1N9Zr0: Bottom of 3D print
©
W1N9Zr0: First coat of primer
©
W1N9Zr0: More primer
©
W1N9Zr0: And more primer...
©
W1N9Zr0: A lot of primer
©
W1N9Zr0: Bubbles from too much primer
©
W1N9Zr0: Let's try the nice KISSlicer print
©
W1N9Zr0: Some small bumps in the print, otherwise very good
©
W1N9Zr0: First coat of primer!
©
W1N9Zr0: Slowly adding primer
©
W1N9Zr0: Check all sides for what else needs filling
©
W1N9Zr0: Big blobs of PLA on this side
©
W1N9Zr0: Still needs more primer
©
W1N9Zr0: Getting close
©
W1N9Zr0: Getting really smooth
©
W1N9Zr0: IMG_2298
©
W1N9Zr0: IMG_2311
©
W1N9Zr0: Probably should have sanded the blobs off first
©
W1N9Zr0: Primer overspary
©
W1N9Zr0: Attempting to sand 0.2mm print
©
W1N9Zr0: Sanding good print
©
W1N9Zr0: Sanded flat
©
W1N9Zr0: Sanded another scrap piece down to the PLA
©
W1N9Zr0: Good piece sanded and polished
©
W1N9Zr0: New coat of primer
©
W1N9Zr0: Black marker to check surface
©
W1N9Zr0: Molding main gem
©
W1N9Zr0: Silicon not mixed very well