©
ukpylot: Measuring Z-angles for rear fuselage strenghening
©
ukpylot: Measuring Z-angles for rear fuselage strenghening
©
ukpylot: Measuring Z-angles for rear fuselage strenghening
©
ukpylot: Placing longerons against bottom skin
©
ukpylot: Placing longerons against bottom skin
©
ukpylot: Longerons drilled on bottom skin
©
ukpylot: Z-angle stiffeners drilled on bottom skin
©
ukpylot: Z-angle stiffeners first drill
©
ukpylot: L-angles cut for stiffeners
©
ukpylot: Checking fit of bottom skin stiffeners
©
ukpylot: We turned the crate into a movable bench
©
ukpylot: Bottom skin stiffeners clecoed
©
ukpylot: Bottom skin stiffeners all drilled out
©
ukpylot: Trial fitting nut plate
©
ukpylot: Nut plates all drilled
©
ukpylot: Bottom skin gussets drilled out
©
ukpylot: Ready to rivet a nut plate
©
ukpylot: Riveted bottom skin l-angles
©
ukpylot: Clean side skin
©
ukpylot: Side skin and rear side skin attached
©
ukpylot: Bottom skin completely drilled out
©
ukpylot: Right hand side skin longeron drilled
©
ukpylot: l-angle stiffeners cut and ready to go
©
ukpylot: Placing l-angle stiffeners on right hand side skin
©
ukpylot: Drilling side skin for HT Frames
©
ukpylot: Side skin drilled for HT Frames
©
ukpylot: Me doing something
©
ukpylot: Right side skin stiffener holes primed
©
ukpylot: Right side skin stiffeneres riveted
©
ukpylot: HT Frames clecoed to bottom skin