stormtrooperguy:
Profile
stormtrooperguy:
Made a big lip on the bottom and cross-braced
stormtrooperguy:
Here's where I started
stormtrooperguy:
After slush casting
stormtrooperguy:
Starting to remove the tape and plastic
stormtrooperguy:
Quick coat of dark primer
stormtrooperguy:
Camera Roll-509
stormtrooperguy:
Sand, prime, repeat
stormtrooperguy:
Just about done smoothing out polygons
stormtrooperguy:
Just about smooth
stormtrooperguy:
A bit more sanding to go, but closer.
stormtrooperguy:
Sketching out the pattern
stormtrooperguy:
Rough lines for the details
stormtrooperguy:
Circling problem areas
stormtrooperguy:
Symmetry is the enemy
stormtrooperguy:
Closing in the eyes
stormtrooperguy:
Checking the "good" side
stormtrooperguy:
Brow trim is off
stormtrooperguy:
Fixing the bottom edge of the helmet
stormtrooperguy:
Profile shot
stormtrooperguy:
Adding the other part of the X back
stormtrooperguy:
Top is too round
stormtrooperguy:
Left side
stormtrooperguy:
Reference and the helmet
stormtrooperguy:
Starting to build out the trim.
stormtrooperguy:
I am the (dusty) law
stormtrooperguy:
Cleaning up the helmet
stormtrooperguy:
Looking nice and clean
stormtrooperguy:
I can start to see where this is going
stormtrooperguy:
Test fit with a visor in place
