Rock The Bike:
The parts of the light tower.
Rock The Bike:
Fully assembled, the bottom of the red panel will touch the floor.
Rock The Bike:
Extend the tripod base of the stand to the widest it goes.
Rock The Bike:
Find the extension tube and take out the wingnut and handscrew.
Rock The Bike:
Extend the top tube of the stand with the helper tube. Line up the holes. Then use the handscrew and wingnut to attach it.
Rock The Bike:
Attach the top panel (green and halogens) by sleeving the T-junction shown here over the extended top tube.
Rock The Bike:
Use the thumbscrews on the T-junction to tighten this connection.
Rock The Bike:
One of the red/black wires coming out of the halogen section is labeled "back of green panel". Connect it to the stubby wire with matching connector coming from the bottom of the green panel as shown. Red goes to Red. Black goes to black. Push.
Rock The Bike:
The blue panel sleeves into the bottom of the green panel. Swing the green panel out and insert.
Rock The Bike:
Rout all the wires along the back. If a wire falls as shown here it will prevent you from lining up the holes for the handscrews and wingnuts.
Rock The Bike:
Use handscrews and wingnuts to connect the blue panel to the green.
Rock The Bike:
Find the red/black wire from the halogens that's the middle length. It will hang about where it's supposed to be connected. It's labeled "back of upper blue panel"
Rock The Bike:
Raise the main pole of the stand. Use an assistant!
Rock The Bike:
Look for "Last Hole Use Pin". Then use the pin through the hole, and then tighten the handscrew.
Rock The Bike:
Using pin on the 'last hole'.
Rock The Bike:
Using the handscrew.
Rock The Bike:
The red panel connects the blue panel with this helper piece. Find it in the box of handscrews. Line it up as shown.
Rock The Bike:
Don't drop the helper piece down the hole. Hold it while you use the handscrew.
Rock The Bike:
Insert the red panel with the helper piece.
Rock The Bike:
Use the handscrews to attach it to the lower blow panel.