JD and Beastlet:
Ignition wire keep - slack position
JD and Beastlet:
Cowl off for the DLE 20 de-install
JD and Beastlet:
Strap off the battery box
JD and Beastlet:
Cutting the zip ties holding the ignition
JD and Beastlet:
Ignition wire keep - tightened position
JD and Beastlet:
Battery box open
JD and Beastlet:
Checking for for holes... close but no cigar
JD and Beastlet:
Again, close...
JD and Beastlet:
DLE 20 and RCGF 32 side by side
JD and Beastlet:
DLE 20 and RCGF 35, from the front. Top?
JD and Beastlet:
RCGF 35 - 168mm from firewall to back plate
JD and Beastlet:
DLE 20 - 162mm from firewall to back plate
JD and Beastlet:
Hitec digital servos
JD and Beastlet:
Futaba R6208SB Receiver
JD and Beastlet:
Aura 8 - S.Bus for Stearman
JD and Beastlet:
Aura 8 for Super Stearman
JD and Beastlet:
I think I'll put it here. Pins face aft, mini sockets face port
JD and Beastlet:
Aura 8 stuck and strapped in place, all connections made
JD and Beastlet:
Removing the analog elevator servo
JD and Beastlet:
Digital elevator servo installed
JD and Beastlet:
Digital rudder servo installed*
JD and Beastlet:
Aura 8 strapped in place, connections made
JD and Beastlet:
R6208SB receiver installed
JD and Beastlet:
Starboard aileron - 01
JD and Beastlet:
Starboard aileron - 02
JD and Beastlet:
Aura 8 - Super Stearman
JD and Beastlet:
Aura 8 tx config
JD and Beastlet:
Starboard aileron - 03
JD and Beastlet:
Starboard aileron - 04
JD and Beastlet:
Starboard aileron - 05
