©
JD and Beastlet: Impact driver
©
JD and Beastlet: New seal
©
JD and Beastlet: New piston spring
©
JD and Beastlet: Trying the Banjo bolt
©
JD and Beastlet: The banjo bolt
©
JD and Beastlet: Old and new seals and springs
©
JD and Beastlet: Springs look the same
©
JD and Beastlet: New seal is newer
©
JD and Beastlet: Soaking the new seal in DOT4
©
JD and Beastlet: Wisdom from the manual
©
JD and Beastlet: Fresh gloves
©
JD and Beastlet: Seal installed
©
JD and Beastlet: Coating the cylinder bore
©
JD and Beastlet: Ready to install the piston
©
JD and Beastlet: Piston's in!
©
JD and Beastlet: Clutch release cylinder back in place
©
JD and Beastlet: Cylinder bolted on
©
JD and Beastlet: Bleed screw and cap reattached
©
JD and Beastlet: Piston retained cover bolted in
©
JD and Beastlet: Ready to reinstall the cover
©
JD and Beastlet: Cover in place
©
JD and Beastlet: Starting with the centre bolt
©
JD and Beastlet: Clutch and kickstand switch wire grommet
©
JD and Beastlet: Grommet in place
©
JD and Beastlet: New Banjo bolt
©
JD and Beastlet: Banjo bolt installed
©
JD and Beastlet: All together
©
JD and Beastlet: All together again
©
JD and Beastlet: Poor empy bolt map
©
JD and Beastlet: Out comes the mityvac to bleed the clutch