JD and Beastlet:
Filling the ballast weight screw holes
JD and Beastlet:
Time to cut the plugs flush
JD and Beastlet:
Plugs cut flush
JD and Beastlet:
Firewall 140 mm wide
JD and Beastlet:
Standoff length and offset calculation
JD and Beastlet:
RCGF 30cc twin - cowl clearance
JD and Beastlet:
RCGF 30cc twin is here
JD and Beastlet:
Mounting hardware
JD and Beastlet:
Engine test mount - front
JD and Beastlet:
Engine test mount - starboard
JD and Beastlet:
Ignition location
JD and Beastlet:
Plugging and cutting
JD and Beastlet:
Plugging the firewall holes
JD and Beastlet:
Mounting block on bolts
JD and Beastlet:
Plugging almost done
JD and Beastlet:
Test mount #2 - 01
JD and Beastlet:
Test mount #2 - 02
JD and Beastlet:
Test mount #2 - 03
JD and Beastlet:
Test mount #2 - 04
JD and Beastlet:
Throttle rod hole
JD and Beastlet:
Fuel line hole
JD and Beastlet:
Home Hardware rust paint
JD and Beastlet:
Coordinated with airplane colours
JD and Beastlet:
Cutting off the old cowl mounts
JD and Beastlet:
Block glued and bolted - 01
JD and Beastlet:
Block glued and bolted - 02
JD and Beastlet:
Filler on the firewall
JD and Beastlet:
Heat shrink spacer
JD and Beastlet:
Spacer, further back
JD and Beastlet:
Prop shaft thread - M8 x 1.00
