JD and Beastlet:
MPI crimpers with information*
JD and Beastlet:
Crimping the pins*
JD and Beastlet:
Placement of insulation and stripped wire*
JD and Beastlet:
Checking wire placement - correct
JD and Beastlet:
Correct end - cover slides farther onto plug and stays in place
JD and Beastlet:
Incorrect end - second indication
JD and Beastlet:
Incorrect end - first indication
JD and Beastlet:
Male pins before female cover attached
JD and Beastlet:
3. Pinch insulation tang with other hand
JD and Beastlet:
2. Hold wire in place with one hand
JD and Beastlet:
1. Push wire down into connector (do not slide in)
JD and Beastlet:
Stripping 1/8 in of wire*
JD and Beastlet:
Placement of insulation and stripped wire
JD and Beastlet:
TBRC (left) vs MPI (right) crimpers
JD and Beastlet:
MPI crimpers - close
JD and Beastlet:
Male pin
JD and Beastlet:
Negative on the right, open crimped ends face up
JD and Beastlet:
2015-11-23_02-11-36
JD and Beastlet:
Female pin diagram
JD and Beastlet:
Male pin diagram
JD and Beastlet:
Tools and supplies*
JD and Beastlet:
Female pin
JD and Beastlet:
Proper crimp - open end
JD and Beastlet:
Proper crimp - closed end
JD and Beastlet:
Proper orientation of pin and connector
JD and Beastlet:
Measuring a 12" extension*
JD and Beastlet:
Holding the conductors together
JD and Beastlet:
Cutting the conductors
JD and Beastlet:
Proper wire sequence
JD and Beastlet:
4 x 12" extensions