JD and Beastlet:
Pulse gear mount damage
JD and Beastlet:
Damage from hard landing - will no longer use LG reinforcement
JD and Beastlet:
Starboard rear bolt out, gear flopped back
JD and Beastlet:
Damage from port
JD and Beastlet:
Damage from starboard
JD and Beastlet:
Plate separating
JD and Beastlet:
Better keep this piece
JD and Beastlet:
Easing the plate up
JD and Beastlet:
(Most of) plate off
JD and Beastlet:
Plate off
JD and Beastlet:
Tabs weren't glued!
JD and Beastlet:
Spark plug wire needs a path the size of the cap
JD and Beastlet:
Cutting out the tri-stock
JD and Beastlet:
Separating the tri-stock
JD and Beastlet:
Tri stock out
JD and Beastlet:
Fuse side with removed tri-stock
JD and Beastlet:
Might move the plug wire cover here
JD and Beastlet:
Propped up for bulhead cuts
JD and Beastlet:
Line marks a quarter inch to come off
JD and Beastlet:
First the rotary tool
JD and Beastlet:
Finish with the flush-cut saw
JD and Beastlet:
A quarter inch off
JD and Beastlet:
Rough cuts
JD and Beastlet:
Time to cut the new base
JD and Beastlet:
Raising the cut bulkheads a little
JD and Beastlet:
New base, test fit
JD and Beastlet:
New base as a sanding plate
JD and Beastlet:
Paper on
JD and Beastlet:
Ready to sand
JD and Beastlet:
Still a gap at the back
