JD and Beastlet:
Make tapped bolt holder
JD and Beastlet:
Robertson head formed
JD and Beastlet:
Completed flat head bolt
JD and Beastlet:
Bolt with slag
JD and Beastlet:
Drive heated bit into bolt
JD and Beastlet:
Mount bolt in base
JD and Beastlet:
Screw it in
JD and Beastlet:
Screwed in
JD and Beastlet:
Note alignment mark
JD and Beastlet:
Raise table to aligment mark
JD and Beastlet:
Tap to change lateral position
JD and Beastlet:
Check alignment of bit on bolt
JD and Beastlet:
Fire up blowtorch
JD and Beastlet:
Heat bit
JD and Beastlet:
Robertson formed
JD and Beastlet:
Cut away slag
JD and Beastlet:
Remove bolt from table
JD and Beastlet:
Slag
JD and Beastlet:
Finished bolt
JD and Beastlet:
Don't go too deep
JD and Beastlet:
Four finished bolts
JD and Beastlet:
Bucket o' wire nuts
JD and Beastlet:
Perfect fit
JD and Beastlet:
DUB142 1-4-20 Nylon Wing bolts - three packages
JD and Beastlet:
Rough metal for the wing bolt driver tool
JD and Beastlet:
Metal cut, shaped and JB-welded in place
JD and Beastlet:
Wing bolt at correct depth
JD and Beastlet:
Du-Bro 1-4-20 wing bolt
JD and Beastlet:
Wing bolt head
JD and Beastlet:
3/16" inset hex head
