JD and Beastlet:
3-8 in PEX toilet supply pipe
JD and Beastlet:
3-8 in PEX toilet supply pipe - label
JD and Beastlet:
1-4 20 x 2-1-2 in nylon bolt
JD and Beastlet:
Bolt in pipe
JD and Beastlet:
Wing bolt mounts
JD and Beastlet:
Wing bolt mounts
JD and Beastlet:
Replacing the stock wing strap screws - original, replacement and replacement cut to fit
JD and Beastlet:
Replacement cut to fit
JD and Beastlet:
Replacements in
JD and Beastlet:
Crappy POS hateful rounded Phillips
JD and Beastlet:
The replacements
JD and Beastlet:
Got to cut off the old aileron rods
JD and Beastlet:
Cut down
JD and Beastlet:
Wind saddle marked on upper wing surface
JD and Beastlet:
Test ft of the mounting blocks
JD and Beastlet:
Test tap of a 1/4"-20 hole
JD and Beastlet:
Lots of strength
JD and Beastlet:
Rear mount clamped for drilling
JD and Beastlet:
Wing bolt pattern
JD and Beastlet:
Rubber bands on the wing
JD and Beastlet:
Pilot holes on the port side for the rear wing bolt mount
JD and Beastlet:
Both mounts bolted in
JD and Beastlet:
Control rods ground down, workable area outlined
JD and Beastlet:
Holes drilled
JD and Beastlet:
Wing profile
JD and Beastlet:
A little CA in the mount screw holes
JD and Beastlet:
CA in
JD and Beastlet:
Mount screws coloured black
JD and Beastlet:
Single servo frame removed from starboard wing
JD and Beastlet:
Ruh roh - this isn't going to work
