JD and Beastlet:
Ski and wheel - version 2
JD and Beastlet:
Ski and wheel - version 3
JD and Beastlet:
Ski and wheel - version 3.1
JD and Beastlet:
Axle setup v1 - 01
JD and Beastlet:
Axle setup v1 - 02
JD and Beastlet:
Axle setup v1 - 03
JD and Beastlet:
Axle setup v1 - 04
JD and Beastlet:
Two 20 x 4 in skis
JD and Beastlet:
Squaring the stop block
JD and Beastlet:
Both skis against the stop block
JD and Beastlet:
Rough opening marked
JD and Beastlet:
15/64" holes for hole saw
JD and Beastlet:
Hole saw on drill
JD and Beastlet:
One hole drilled
JD and Beastlet:
Both holes drilled
JD and Beastlet:
A chisel to flatten out the inside
JD and Beastlet:
Hole cutout complete
JD and Beastlet:
Good fit of tire in hole
JD and Beastlet:
Ski too long
JD and Beastlet:
Ski shortened
JD and Beastlet:
Medium grit foam back sandpaper to clean up the holes - 01
JD and Beastlet:
Medium grit foam back sandpaper to clean up the holes - 02
JD and Beastlet:
Medium grit foam back sandpaper to clean up the holes - 03
JD and Beastlet:
Compass to draw tip
JD and Beastlet:
Tip cut out on bandsaw
JD and Beastlet:
1/4" ply for spine - marking the upsweep
JD and Beastlet:
Forward spines - blanks joined
JD and Beastlet:
Forward spines
JD and Beastlet:
Rear spines
JD and Beastlet:
Forward spines - waste joined for cutting to length
