JD and Beastlet:
RCGF 32 mounting template
JD and Beastlet:
DLE 20 in
JD and Beastlet:
DLE 20 out
JD and Beastlet:
Filling the old engine mount holes
JD and Beastlet:
Template for new engine mount holes
JD and Beastlet:
Holes drilled
JD and Beastlet:
Bolts in
JD and Beastlet:
Mounts on
JD and Beastlet:
Test fit - 1
JD and Beastlet:
Test fit - 2
JD and Beastlet:
Test fit - 3
JD and Beastlet:
Drive washer should be 140 mm from firewall
JD and Beastlet:
That don't look right
JD and Beastlet:
That don't look right either
JD and Beastlet:
Neither does that
JD and Beastlet:
Drive washer is 170 mm from firewall
JD and Beastlet:
Standoffs are 72mm
JD and Beastlet:
Need 42mm (or slighly shorter)
JD and Beastlet:
New parts - Gold-n-Rod
JD and Beastlet:
New parts - 16 x 10 3-blade and spinner
JD and Beastlet:
New parts - Bolt-on pressure fitting
JD and Beastlet:
New parts - EZ Connectors
JD and Beastlet:
New parts - 2-56 Ball Link
JD and Beastlet:
RCGF carb - original position
JD and Beastlet:
RCGF card - rotated 180 degrees
JD and Beastlet:
Removing the choke linkage
JD and Beastlet:
Exhaust port covered
JD and Beastlet:
Removing the cylinder head bolts
JD and Beastlet:
Original ring - very sloppy
JD and Beastlet:
Bowman ring - running around the groove
