JD and Beastlet:
Old mount holes for main gear
JD and Beastlet:
Ignition and gas tank removed
JD and Beastlet:
New location - forward 3-4 in
JD and Beastlet:
Marking the new forward holes
JD and Beastlet:
Removing the covering from the new holes
JD and Beastlet:
First set was too far wide. New set of front holes
JD and Beastlet:
Reinforcing block glued and clamped
JD and Beastlet:
DLE 20 head on
JD and Beastlet:
New vent line fitting
JD and Beastlet:
DLE 20 marking
JD and Beastlet:
Second reinforcent clamped
JD and Beastlet:
Test fit - 500 mL Fiji bottle
JD and Beastlet:
Vent outlet
JD and Beastlet:
Reinforcement blocks in
JD and Beastlet:
Choke lever covered
JD and Beastlet:
Main gear bolt - washer tape on
JD and Beastlet:
Blind nut holder
JD and Beastlet:
Leading edge of riser block marked
JD and Beastlet:
Peeling back the skin for surgery
JD and Beastlet:
Marking for removal
JD and Beastlet:
Removed
JD and Beastlet:
Recovered
JD and Beastlet:
Filler applied and sanded
JD and Beastlet:
All patched up
JD and Beastlet:
Unused holes covered
JD and Beastlet:
Main gear attached
JD and Beastlet:
Main gear
JD and Beastlet:
TnT gear clamped for wheel removal
JD and Beastlet:
Wheels back on the stock gear
JD and Beastlet:
Wheel close