JD and Beastlet:
5L gas can
JD and Beastlet:
New parts - fuel cap fitting
JD and Beastlet:
Instructions
JD and Beastlet:
Gas can in tote
JD and Beastlet:
Cap, stopper and spout
JD and Beastlet:
Rotary cutting disc cut down with scissors
JD and Beastlet:
Gas cap - inner ring needs removing
JD and Beastlet:
The trimmed cutting disc
JD and Beastlet:
Inner ring removed
JD and Beastlet:
Inside of stopper smoothed
JD and Beastlet:
Tab on top of stopper removed
JD and Beastlet:
Marking the spout for cutoff
JD and Beastlet:
Hold the pen, turn the spout
JD and Beastlet:
Voila
JD and Beastlet:
Let's make it a little longer
JD and Beastlet:
Cut down
JD and Beastlet:
The stub of the spout still acts as a gasket in the tank
JD and Beastlet:
Pilot hole marked inside stopper
JD and Beastlet:
Pin vise for the pilot hole
JD and Beastlet:
Half inch forstner bit for the fitting
JD and Beastlet:
Nice, clean hole
JD and Beastlet:
Plumbing inside of the cap
JD and Beastlet:
Fitting outside of the cap
JD and Beastlet:
Fitting on the can
JD and Beastlet:
grosbeak on the gas can caddy
JD and Beastlet:
White nut - 11-16 in spark plug socket
JD and Beastlet:
Fuel pump plumbed in
JD and Beastlet:
Pocket for fuel pump
JD and Beastlet:
Can ready!
JD and Beastlet:
2-stroke oil for 5L of gas