JD and Beastlet:
grosbeak avatar with reg
JD and Beastlet:
Starting table
JD and Beastlet:
Starting table
JD and Beastlet:
This is going to take a while
JD and Beastlet:
Servo and rx locations - diagram
JD and Beastlet:
Soldering 4-40 threaded rod between 4-40 pushrods
JD and Beastlet:
Soldering together 3 x 4-40 pushrods
JD and Beastlet:
Dual pushrods
JD and Beastlet:
Engine placement
JD and Beastlet:
DLE 20 measurements
JD and Beastlet:
Wing bolt shape
JD and Beastlet:
Gas vent line fitting
JD and Beastlet:
Engine mount and thrust line (engine mounting tab shown)
JD and Beastlet:
Engine mount and thrust line - revised
JD and Beastlet:
T6J Chart
JD and Beastlet:
Garage 2x4 tire rack - Side elevation
JD and Beastlet:
Garage 2x4 tire rack - Front elevation
JD and Beastlet:
Garage 2x4 tire rack - Plan
JD and Beastlet:
Garage 2x4 tire rack - Materials
JD and Beastlet:
64ths and 0.5mm ruler - with guides
JD and Beastlet:
Landing gear bracing
JD and Beastlet:
Pulse 125 - R617FS receiver channel allocation
JD and Beastlet:
Rudder servo inset placement
JD and Beastlet:
Choke linkage
JD and Beastlet:
Servo arm length = control horn length
JD and Beastlet:
Threaded rod length
JD and Beastlet:
Aluminum tube length
JD and Beastlet:
Control link thread
JD and Beastlet:
Link pin to threaded rod
JD and Beastlet:
Optical ignition cutoff setup
