JD and Beastlet:
DLE 20 is here
JD and Beastlet:
The box is open
JD and Beastlet:
Everything's insde
JD and Beastlet:
Ignition
JD and Beastlet:
Muffler bolts and gasket, extended throttle arm
JD and Beastlet:
Muffler
JD and Beastlet:
First close look
JD and Beastlet:
From the top
JD and Beastlet:
CCW from left - choke actuator, throttle actuator, fuel inlet
JD and Beastlet:
Idle and top end settings
JD and Beastlet:
The business end
JD and Beastlet:
Inverted
JD and Beastlet:
Inverted - further out
JD and Beastlet:
Down the cylinder
JD and Beastlet:
There's that business end again
JD and Beastlet:
Muffler side
JD and Beastlet:
Mounts on temporary board
JD and Beastlet:
A convenient measuring point
JD and Beastlet:
5-1-2 in from firewall to front of thrust washer
JD and Beastlet:
Two bolts mounted
JD and Beastlet:
All four holes made
JD and Beastlet:
Pitts muffler side box template
JD and Beastlet:
Trimming to fit the muffler
JD and Beastlet:
Ready to cut
JD and Beastlet:
Cut - needs some finessing
JD and Beastlet:
Engine and muffler installed
JD and Beastlet:
Cowl cutout - side profile
JD and Beastlet:
Cowl cutout - bottom profile
JD and Beastlet:
Bottom profile removed
JD and Beastlet:
Templates folded back
