©
ッ Andrei: gel holder + gel attached to flash
©
ッ Andrei: two plastic gel holders compared to a gel sized rosco sample
©
ッ Andrei: gel holder + gel attached to flash
©
ッ Andrei: gel holder attached to flash
©
ッ Andrei: gel holder attached to flash
©
ッ Andrei: add more glue dots
©
ッ Andrei: add glue dots
©
ッ Andrei: IMG_1693
©
ッ Andrei:
©
ッ Andrei: IMG_1690
©
ッ Andrei: gel holder bent incorrectly - just heat it again and fix the angle
©
ッ Andrei: bend the plastic while it's warm
©
ッ Andrei: HEAT THE PLASTIC with the torch lighter
©
ッ Andrei: use the knife to smooth out edges - no sand paper
©
ッ Andrei: stare in awe at the gel holder once in a while
©
ッ Andrei: more smoothing out
©
ッ Andrei: aerial shot
©
ッ Andrei: reinforcing the "line" (scratch)
©
ッ Andrei: IMG_1680
©
ッ Andrei: IMG_1679
©
ッ Andrei: mark the sizes
©
ッ Andrei: tear the plastic
©
ッ Andrei: try to tear the plastic
©
ッ Andrei: cut the curve of the holder
©
ッ Andrei: more scratching
©
ッ Andrei: picture frame (notice my assistant with the remote)
©
ッ Andrei: more scratching (inludes partial assistant view)
©
ッ Andrei: more scratching
©
ッ Andrei: marking dimensions
©
ッ Andrei: exemplifying the torch