paulszym:
Step 01 - Measure and Cut the outer casing of the lead
paulszym:
Step 02 - Strip the outer casing from the lead
paulszym:
Step 03 - Separate shielding wire in half
paulszym:
Step 04 - Twist the shielding wire
paulszym:
Step 05 - Cut off the excess ground wire
paulszym:
Step 06 - Strip the data and power wires
paulszym:
Step 07 - "Tin" the exposed wire
paulszym:
Step 08a - Confirm the Red wire traces to the tip
paulszym:
Step 08b - Check the White wire traces to the ring
paulszym:
Step 08c - Check the Shield wire trace to the casing
paulszym:
Step 09 - Check 5mm sensor pin outs
paulszym:
Step 09a - Prepare the 5mm Sensor
paulszym:
Step 10 - Place the 5mm Sensor for soldering
paulszym:
Step 11 - "Tin" the 5mm sensor pins
paulszym:
Step 12 - Place the sensor lead cable for soldering
paulszym:
Step 13 - Solder the Shielding wire to the Ground pin
paulszym:
Step 14 - Align the Red wire with the Output pin
paulszym:
Step 15 - Solder the Red wire to the Output pin
paulszym:
Step 16 - Prepare the White wire
paulszym:
Step 17 - Position and solder the white wire to the Vs pin
paulszym:
Step 18 - Place the smaller heat shrink over each pin
paulszym:
Step 19 - Apply the smaller heat shrink
paulszym:
Step 20 - Gently push pins back into place
paulszym:
Step 21 - Gently slide the large heat shrink over the wires
paulszym:
Step 22 - Gently push the large heat shrink up to the sensor wires
paulszym:
Step 23 - Apply heat to the larger heat shrink
paulszym:
Step 24 - Basic assembly completed
paulszym:
Step 25 - Warm up the hot glue gun
paulszym:
Step 26 - Plan your glue attack
paulszym:
Step 27 - Apply your glue and smooth it out
