©
Qvidja50: R/C lamp
©
Qvidja50: Ruth's Lamp
©
Qvidja50: Sand Cast Form
©
Qvidja50: Sand Cast Form
©
Qvidja50: Incubator Parts for Lamp
©
Qvidja50: Lamp/Heater for Chick Incubator
©
Qvidja50: Iittala Base 1:1 drawing for top deck
©
Qvidja50: Iittala Base - frosted acrylic for top deck
©
Qvidja50: Iittala Base - dado cut on side rail
©
Qvidja50: Iittala Base - drilling top deck screw holes with pattern
©
Qvidja50: Iittala Base - dado cut side rail with base trim
©
Qvidja50: Iittala Base - ripping acrylic for top deck
©
Qvidja50: Iittala Base - drilling top deck screw holes
©
Qvidja50: Iittala Base - drilling top deck
©
Qvidja50: Iittala Base - top deck top view
©
Qvidja50: Iittala Base - top deck bottom view
©
Qvidja50: Iittala Base - test fit with glasses
©
Qvidja50: Iittala Base - side rails and top plate
©
Qvidja50: Iittala Base with two LEDs
©
Qvidja50: Iittala Base with two glasses
©
Qvidja50: Iittala Base - drilling vents
©
Qvidja50: Iittala Base - re-wiring circuit board to control dimmer
©
Qvidja50: Iittala Base prepped for urethane finish
©
Qvidja50: Iittala Base - re-configuring LEDs
©
Qvidja50: Iittala Base - test layout of eight LEDs
©
Qvidja50: Iittala Base - smoke test of first four LEDs
©
Qvidja50: Iittala Base - preliminary fitting test for LED deck
©
Qvidja50: Iittala Base - drilling holes to secure LEDs
©
Qvidja50: Iittala Base - smoke test with all LEDs installed
©
Qvidja50: Iittala Base - gluing support blocks for LED deck