©
Lawdeda ♡: Backplate and scalp are attached
©
Lawdeda ♡: The back and scalp of SBL Blythe
©
Lawdeda ♡: SBL Faceplate
©
Lawdeda ♡: Inside the faceplate
©
Lawdeda ♡: Step 1: Undo this screw to take out the t-bar
©
Lawdeda ♡: Tools and sbl Faceplate with eyemech
©
Lawdeda ♡: Step 2: Eye mech removal
©
Lawdeda ♡: Step 3: Eye mech is out and once you have the one side out you just pull it out.
©
Lawdeda ♡: Inside the SBL head
©
Lawdeda ♡: That little plastic arch has to come off to take the eyes out
©
Lawdeda ♡: I use a flat nail tool to carefully pop the end piece out of the hole.
©
Lawdeda ♡: Eyes out of Eye Mech
©
Lawdeda ♡: I put that little divot on each eyelid and it allows them to be boggled
©
Lawdeda ♡: What the lids look like to be boggled
©
Lawdeda ♡: EBL Posts to Boggle her
©
Lawdeda ♡: Keyko's Head (EBL)
©
Lawdeda ♡: Boggling Before & After
©
Lawdeda ♡: What the spring is attached to
©
Lawdeda ♡: RBL Have 3 Screws
©
Lawdeda ♡: If you unscrew the screw at the top of the inside of her faceplate you can pop her head dome and scalp off
©
Lawdeda ♡: Inside the RBL
©
Lawdeda ♡: 101/366 When you pop the RBL apart she should be in these pieces
©
Lawdeda ♡: RBL Backplate
©
Lawdeda ♡: Back of the RBL head
©
Lawdeda ♡: Inside the RBLI
©
Lawdeda ♡: RBL Head
©
Lawdeda ♡: Baahhhhh I almost got it out perfectly
©
Lawdeda ♡: And then right when I was about to pull it all the way free
©
Lawdeda ♡: Wonderful Headwrap right lol
©
Lawdeda ♡: EBL OPENING: The tools you need to get started