©
bubbaisme: Snapper42" oldie but still cuts grass. July 2014 new to me.
©
bubbaisme: Snapper, needs new front tires and steering repaired
©
bubbaisme: B&S V Twin, compression on both cyl is 140 PSI, full tune up and oil & filter
©
bubbaisme: Snapper 42" needs some rehabbing but runs and mows OK, as is.
©
bubbaisme: Snapper 42" rider 421613 BVE Series 13 1992-1994
©
bubbaisme: Snapper steering wheel. Grant GT, leather, 13"
©
bubbaisme: Grant leather wheel. Was on the Stalker B4 the new flat bottom wheel.
©
bubbaisme: Old Snapper and new quick disconnect wheel. Quick disconnect hub on steering shaft.
©
bubbaisme: Snapper steering wheel, original that would not come off shaft without cutting shaft.
©
bubbaisme: Snapper steering wheel that had to be cut off to free shaft for rebuild.
©
bubbaisme: Had to cut old wheel off with hacksaw
©
bubbaisme: Snapper steering wheel was corrosion welded to shaft
©
bubbaisme: 3 of 6 worn out steering bushings, 3 completely missing.One broken tie rod end w/ modification.
©
bubbaisme: Snapper Dash, cleaned up and re-stenciled.
©
bubbaisme: LH axle with new drive bolt.
©
bubbaisme: Broken rear axle drive bolt. This bolt attaches the axle to the wheel hub. It was still in the hub, held in by the rust. New one on right.
©
bubbaisme: LH drive hub,new drive bolt, grease cap still good as is the internal oil seal inside grease cap.
©
bubbaisme: LH side of mower with drive hub on axle.
©
bubbaisme: RH axle,new drive bolt,hub and wheel studs. RH axle has zerk for lubing. Drive bolt not broken on this side but replaced it anyway.
©
bubbaisme: Freshly painted wheel. Rust inside wheel because of the use of fix a flat slime.
©
bubbaisme: Broke the bead on the left tire and the inside was still shiny factory fresh unlike the right wheel.
©
bubbaisme: Refurbished wheel and hub minus hub cap
©
bubbaisme: Refurbished wheel with new wedge bolt
©
bubbaisme: Hand knobs for seat adjustment and new drink holder. There is a steel bean can inside cozzie that bolts to the bracket.
©
bubbaisme: Drink holder bolted to unused bracket on side of seat mount.
©
bubbaisme: Snapper 42 test
©
bubbaisme: Stock plastic battery box/holder was missing, probably because it was plastic and had broken so I made an aluminum one.
©
bubbaisme: Battery box/holder, holes in box fit over pins. Box flexes enough to be flexed open and then snaps over pins.
©
bubbaisme: No box/holder. I had a piece of wire holding the battery in B4.
©
bubbaisme: No box/holder. Two of the four pins are visible.