dreamexplorer:
IMG_3538-gantry and torch control, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3540-checking torch consumables, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3542-setting amperage, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3544-torch, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3549-placing your material, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3553-connecting air to water tank to raise bed levels, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3555-raising the water level on the table, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3559-grounding the nearest slat to your material, notice cord goes UNDER gantry, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3560-manually jogging the gantry, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3557-hearts and a proper water level for cutting, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3563-set zero before cutting, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3567-zeroing the torch in software, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3568-dry run before enabling cut on the torch, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3570-successful test cuts, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3573-basic settings for male part cut tool, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3575-lead in and lead out settings for male cut tool, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3576-settings for creating an array of parts, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3579-preparing to drain the table after relieving pressure in tank, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3581-ensuring the table draining hose is deep enough, cnc plasma cutter training at Artisan's Asylum
dreamexplorer:
IMG_3583-smoothing the slats with an angle grinder after cutting, cnc plasma cutter training at Artisan's Asylum