David P Best:
F-Rail adapter for Aigner Pressure Modules
David P Best:
Aigner Pressure Wheel on Mounting Bar
David P Best:
Some Aigner Pressure Module Options
David P Best:
Pressure module mounted to Angle Bracket
David P Best:
This is what Felder sells as a complete Pressure Module for P-Channel
David P Best:
Felder "spare part" P-channel mounting block.
David P Best:
P-Channel Adapter for Aigner Pressure Modules
David P Best:
Aigner-supplied Pressure Module adapted to the P-channel
David P Best:
Power Feeder minimum clearance height over pressure module on P-channel
David P Best:
Aigner Centrex
David P Best:
Centrex Components
David P Best:
Riser block for Aigner Centrex
David P Best:
Raised panel processing
David P Best:
Closeup of Cantex in use as a pressure foot
David P Best:
Straddling the sliding table to cast iron top
David P Best:
Setup for raised panel profile
David P Best:
Machining the raised panels for the two end-caps.
David P Best:
Another view - cut the end-grain first, then the long grain
David P Best:
Closeup of clamping arrangement and pressure foot
David P Best:
After minor sanding and BLO - these are samples for profile selection only.
David P Best:
Second test panel with different raised panel profile
David P Best:
Finished profiling panel - needs sanding
David P Best:
Sanding jig for raised panel profile
David P Best:
Detail of sanding jig - sticky-backed sandpaper used with this jig
David P Best:
Raised panels after sanding
David P Best:
Felder Tenoning Plate
David P Best:
Felder Tenoning Plate
David P Best:
Starting work on door frames
David P Best:
Cope cutting setup from above
David P Best:
Cope cutting setup
