David P Best:
Introduction - What's wrong with this fence?
David P Best:
Diagnosis - Part 1 - the 90-degree Stop
David P Best:
Diagnosis - Part 2 - the Pivot Point
David P Best:
Trial Fix - Part 1 - Modifying Felder Pivot Point T-Nut
David P Best:
Trial Fix - Part 3 - Half-Inch Counterbore
David P Best:
Trial Fix - Part 4 - 5/8" Bushing & Counterbore
David P Best:
Trial Fix - Part 5 - Checking Repeatability and Accuracy
David P Best:
Trial Fix - Part 6 - Discovering Sliding Table Slot and T-nut Registration Issues
David P Best:
Trial Fix - Part 7 - Yet Another Alignment Accuracy Issue Found
David P Best:
Short Xcut Fence - Permanent Fix Part 1
David P Best:
Short Xcut Fence - Permanent Fix Part 2
David P Best:
T-Nut for Short Crosscut Fence - Final Version
David P Best:
Short Xcut Fence - Permanent Fix Part 3
David P Best:
Short Production Run - Machining New T-Nuts from 4041 Flat Bar Steel
David P Best:
Short Production Run - After Sizing to Length of 75mm
David P Best:
Short Production Run - Drilling, Tapping and Counterboring the T-Nuts
David P Best:
Short Production Run - After Caswell Oxidation for Rust Prevention
David P Best:
Rethinking the materials - part 1
David P Best:
Rethinking the materials - part 2
David P Best:
Rethinking the materials - part 3
David P Best:
Drilling out the pressed-in bushing - part 1
David P Best:
Drilling out the pressed-in bushing - part 2
David P Best:
Boring bushing counterbore to size
David P Best:
Making the Bronze bushing on the lathe
David P Best:
Testing bushing fit into T-nut counterbore
David P Best:
303 Stainless Steel T-nut with Bronze Bushing
David P Best:
Revised stainless steel T-nut and Bronze bushing
David P Best:
Finished set of new 303 Stainless Steel T-Nuts
David P Best:
Closeup of T-Nut with brass-tipped leveling set screws
David P Best:
Modifications to Clamping Block and Kipp Lever - Final Version
