David P Best:
This is where we're headed - making 6 of these
David P Best:
Raw Matericals - 304 Stainless, 6061 Aluminum, Bronze Rod
David P Best:
1 x 3 x ⅛" 6061 Rectangle Tube - Fence Extension
David P Best:
Raw Materials
David P Best:
Completed Side Rails
David P Best:
Dialing in the Tschorn 3D Edge Finder
David P Best:
Final Check on Tschorn 3D Edge Finder Calibration
David P Best:
Machining the side rails from 304 Hot Rolled
David P Best:
1 x 2 x 3" 304 Stainless Raw Material Arrives
David P Best:
Time to square up this hot rolled 304
David P Best:
Bringing the blocks to size - 1" Iscar Indexable End Mill
David P Best:
Consulting the Drawing for Dimentions
David P Best:
Brining 304 to final thickness - ⅝" Carbide Rougher
David P Best:
Main 304 Stainless Blocks are Square and to Finished Size
David P Best:
IMG_1985
David P Best:
IMG_1987
David P Best:
Checking Tram of Milling Head
David P Best:
Checking Tram of Milling Head
David P Best:
Shirt Fire - Angle Grinder Fire Extingished with Manhattan Cocktail
David P Best:
Shirt Fire - Angle Grinder Fire Extingished with Manhattan Cocktail
David P Best:
Decent Surface Finish for a 4" Indesable Face Mill
David P Best:
Surfacing the 304 Stainless top Plates to 4.6mm Thickness
David P Best:
Slicing up ¼" thick 6061 Flat Bar Stock
David P Best:
Machining Slots in 6061 Micro Adjuster Components
David P Best:
Completed Micro Adjuster Components - 6061
David P Best:
Slotting 6061 - Micro Adjust Block
David P Best:
Slotting 6061 - Micro Adjust Block
David P Best:
Slotting 6061 Aluminum Micro Adjust Blocks
David P Best:
Micro Adjust Blocks
David P Best:
Micro Adjust Blocks - Ready for drilling opearations
