David P Best:
As delivered - about 1800 pounds total
David P Best:
Substantial crating.
David P Best:
Milling head inverted for shipping
David P Best:
After unwrapping
David P Best:
PM-935TS Critical Dimensions
David P Best:
View from other side
David P Best:
Easily lifted with my Big Joe stacker
David P Best:
Motor plate - this will be VFD controlled ultimately
David P Best:
Two-speed motor - probably only use the low speed windings with VFD
David P Best:
Wiring of motor
David P Best:
All cleaned of cosmoline
David P Best:
All cleaned of cosmoline
David P Best:
Gorgeous XY table - dead flat, super smooth ways
David P Best:
Looks funny with the head tilted
David P Best:
Having a true "knee" will be a huge improvement
David P Best:
Making leveling feet platforms - ¼" 3x4 angle
David P Best:
Removed mill scale, eased all corners and edges
David P Best:
Drilling and tapping for leveling feet
David P Best:
Two coats blue paint after priming
David P Best:
The leveling feet
David P Best:
Held onto the machine base with ⅝" All-Thread
David P Best:
Leveling Platforms
David P Best:
Rental Forklift for DIY rigging job
David P Best:
Hacked the forklift - mill off the pallet
David P Best:
Ready to move forward
David P Best:
Out the back of the garage and over the basement entrance
David P Best:
Just cleared the door frame
David P Best:
Hanging out over the basement shaft entrance
David P Best:
Look out below !!!!
David P Best:
View from the basement
