chrisginottawa:
#5 zipper pull secured in vice
chrisginottawa:
#5 zipper pull holder to facilitate installing the zippers
chrisginottawa:
#5 zipper sides installed on zipper pull.
chrisginottawa:
Trimming boss plate for rivets
chrisginottawa:
Rivet base being secured in clamping plate. Ready to trim boss length.
chrisginottawa:
Trimming boss plate for rivets
chrisginottawa:
Making 15mm washers with a perfectly centered rivet boss hole.
chrisginottawa:
Whacking the center hole in a 15mm leather disk.
chrisginottawa:
CS Osbourne punch in centring fixture.
chrisginottawa:
Replacing cracked vinyl pads on spring clamps
chrisginottawa:
Replacing cracked vinyl pads on spring clamps
chrisginottawa:
Modifying a small knuckle press for rivet/snap dies
chrisginottawa:
A super sturdy Astor knuckle press modification.