CGM Gunstock Checkering:
#0960 - Refinish and rechecker in original pattern, repair eatten away areas of butt plate, refinish & recut grooves across face, 28.1 hrs.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Note that safety lever is now in fire position.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Remove machine screw (just behind TG) and wood screw (at end of TG). Lift TG tang out of inlet and unscrew in counter clock-wise direction. Note safety lever is now in safe (vertical) position.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. TG has been removed.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Open action by lifting ears of opening lever up and pull breech block straight back. This exposes a screw that goes down into trigger plate. Remove screw.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Screw removed.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Relative position of removed screw to open action, side view.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. If action has been closed, open it. Push knurled button on bottom of trigger plate in to release internal barrel locking lever.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Holding button in, tap barrels gently from muzzles to rear about 1/4" to dislodge barrels from action. They should lift right out.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Remove machine screw passing from rear end of trigger plate into bottom of action.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Remove screw passing down from action (under where barrels were) into front end of trigger plate.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. When both machine screws have been removed, the trigger plate can be wiggled slightly to drop it out of the butt stock and action.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Trigger plate removed. I found it easier to reassemble with parts on side to keep the knurled button in place when slipping trigger plate back into place.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. With trigger plate removed, butt stock can now be slid off away from action. Note that bknurled button fits into trigger plate from back side and is held in place by spring in frame.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence - do not attempt to disassemble the action and breech block any furhter!! Butt stock can be slid off the back of the action. no further screws are holding it in place. Reassemble in reverse order.
CGM Gunstock Checkering:
Relative position of knurled button that presses against spring mounted in frame to release barrels. See red star.
CGM Gunstock Checkering:
#0960 - Disassembly/reassembly sequence. Remove the last machine screw to enable forearn to be slid off forward action tang.