©
cbonsig: Bowden plug at end of PFA
©
cbonsig: Plug removed
©
cbonsig: Extending less than 8mm
©
cbonsig: Extended to 8mm
©
cbonsig: Gap above plate
©
cbonsig: Inside PEEK
©
cbonsig: PFA tube + filament
©
cbonsig: Messed up PFA tube
©
cbonsig: Short-Axis
©
cbonsig: Long-Axis
©
cbonsig: Oval cross section
©
cbonsig: Cut PFA tube
©
cbonsig: Groove + Taper
©
cbonsig: E-Clip in groove
©
cbonsig: E-Clip end view
©
cbonsig: Clean 8mm PFA tube + Groove + E-Clip
©
cbonsig: Trimming the PFA
©
cbonsig: Reassembled
©
cbonsig: Filament Snap!
©
cbonsig: 2012.09.02 failprint
©
cbonsig: 2012.09.02 failprint
©
cbonsig: 2012.09.02 ground filament
©
cbonsig: 2012.09.02 failprint-2 filament
©
cbonsig: 2012.09.02 failprint #2
©
cbonsig: Dropping the hot end
©
cbonsig: Loose quick-connect
©
cbonsig: 2012.09.03 failprint
©
cbonsig: Success at 220C
©
cbonsig: 2012.09.03 jam #2
©
cbonsig: A series of diappointments