Brook Reams:
Siebenrock Push Rod Tube Mandrel (18 mm)
Brook Reams:
Popsicle Stick
Brook Reams:
Harbor Freight Brushes [SOURCE-Harbor Freight]
Brook Reams:
Loctite "Red" Type 263-Permatex Equivalent (27100)
Brook Reams:
Temperature Pencils-250 F & 275 F
Brook Reams:
EME Stainless Steel Push Rod Tube Set
Brook Reams:
Harbor Freight Brass Brush
Brook Reams:
Use Wire Brush To Burnish Inside of Push Rod Tube Holes
Brook Reams:
Use 600 Wet/Dry Paper To Dull Sharp Edge of Push Rod Tube
Brook Reams:
1/2 Sheet Paper Towel
Brook Reams:
Rolled Up Paper Towel
Brook Reams:
Paper Towel Inserted Inside Push Rod Tube
Brook Reams:
Freezing Push Rod Tubes with Soaked Paper Towel Inserts
Brook Reams:
Note Ridge On Top Of Cylinder Flange
Brook Reams:
Machinist Flat Is Placed On Cylinder Flanger, But NOT On Top Of Ridge
Brook Reams:
Finding The Right Popsicle Stick
Brook Reams:
Using Machinist Flat and Popsicle Stick
Brook Reams:
How To Measure Correct Depth Of Push Rod Tube
Brook Reams:
Push Rod Tube Collar Not Against Ridge
Brook Reams:
Push Rod Tube Collar Against Ridge
Brook Reams:
Heated Cylinder Read For Installing Push Rod Tubes
Brook Reams:
Apply Red Loctite-About 0.5 Inch Wide, 0.5 Inch From End Of Push Rod Tube
Brook Reams:
Smooth Out Loctite
Brook Reams:
Insert Mandrel Into Collar End of Push Rod Tube
Brook Reams:
Insert Tube Into Hole In Cylinder
Brook Reams:
Use Smaller Hammer to Start Tube and For Fine Adjustment
Brook Reams:
Use 2 Lb Maul To Initially Drive The Tube
Brook Reams:
Make Push Rod Tube Depth Measurement-1
Brook Reams:
Mark Push Rod Tube Depth Measurement-2
Brook Reams:
Measuring Push Rod Tube Depth With Machinest Flat & Popsicle Stick
