babababarandon:
Something's brewing.
babababarandon:
Something's brewing.
babababarandon:
IMG_0184
babababarandon:
RAL 3007 - Black Red
babababarandon:
IMG_0194
babababarandon:
IMG_0185
babababarandon:
IMG_0190
babababarandon:
Nitto B115
babababarandon:
Shimergo
babababarandon:
IMG_0192
babababarandon:
The rust ties it all together
babababarandon:
IMG_0186
babababarandon:
IMG_0197
babababarandon:
mismatched
babababarandon:
IMG_0196
babababarandon:
IMG_0198
babababarandon:
Homemade light mount on Nitto M12
babababarandon:
Finally got the Ti Tubus Airy on and puttin' it to use running errands.
babababarandon:
Before the bike was powder coated and went on tour I had some frame mods done to ease dynamo routing and then later I eventually got around to wiring it up. The mods were not planned to the minute detail, just kinda quick and dirty.
babababarandon:
Upgraded wheelset for the tourer.
babababarandon:
3mm OD - Mogami w2330 Coax (microphone) cable is the main cabling I used. Its used between hub and fork crown, between the under forkcrown junction and the rear fender(through the DT)
babababarandon:
Patch using 2 spade connectors, 2 bullet connectors and two short strands of 24AWG cable.
babababarandon:
I put in a QR in the cabling using 2mm bullet connectors. Regular spade terminals are used on the hub.
babababarandon:
Coax comes up from the hub to the canti stud where it meets the twin-ax cable from the headlight. The twinax cable from the headlight also sends(via coax) ground 'n hot wire to the fork crown junction(later to the taillight).
babababarandon:
Cable up from hub and behind it the cable up to fender(taillight)
babababarandon:
Exchange between headlight, hub and taillight. It is a little bulky but is still out of the way of the tire. If we had planned the frame mods better this could have been cleanup up a bit.
babababarandon:
Taillight cable unplugged
babababarandon:
Detail on twin-ax routing and alu guides. 5 or 6mm ID guide on the far left and the rest are 3mm ID. Held in place with marine adhesive. Zipties helped to hold the guides while the adhesive dried in trickier spots.
babababarandon:
Under shrink wrap is the plug between the cable and the light.
