©
Alex1N: Kiowa cockpit bulkheads
©
Alex1N: A few ejector pin marks to fill
©
Alex1N: Some Kiowa a.k.a. Jet Ranger cockpit bits
©
Alex1N: Not a jet-ski
©
Alex1N: Partial cockpit mockup
©
Alex1N: Faulty primer application removed
©
Alex1N: Tamiya primer sprayed over the cleaned-up bits
©
Alex1N: MM Light Ghost Gray [sic.] , plus Tamiya Rubber Black on instrument panel hood
©
Alex1N: MM Olive Drab on seats
©
Alex1N: Test fit of cockpit structure in port fuselage half
©
Alex1N: Kiowa fuselage halves
©
Alex1N: Various bits painted with Tamiya Rubber Black
©
Alex1N: Closer up view of the blackened cockpit bits
©
Alex1N: Pilot’s seat painted (one of two)
©
Alex1N: Instrument panel transfers on
©
Alex1N: Adding a ‘lambswool’ cover to a pilot seat
©
Alex1N: ‘Green zinc chromate primer’ in the transmission ‘differential(?)’ bay and the aft storage compartment
©
Alex1N: ‘Transmission diff’ in place
©
Alex1N: Treated seat and some exceedingly badly painted seatbelts
©
Alex1N: Masking tape masks for the 'lambswool cover' on the other pilot seat
©
Alex1N: Mr Surfacer 500 splodged on with a toothpick
©
Alex1N: Cyclic sticks added
©
Alex1N: Collective levers switched about from the incorrect kit instructions
©
Alex1N: Painted front seats - seatbelts yet to be fixed
©
Alex1N: Belt masks removed
©
Alex1N: Another belt-brushing attempt about to happen
©
Alex1N: Not good - brush too fluffy
©
Alex1N: Red ‘buttons’ on cyclics
©
Alex1N: First masking tape belts - too wide
©
Alex1N: Thinner tape - done