©
Alex1N: Tumbler (forward-reverse) assembly for the Jeffree leadscrew attachment
©
Alex1N: TAIG manual mill in use
©
Alex1N: Three change-gear bobbins with keyways milled
©
Alex1N: Milling the underside of the lathe saddle with a 3/8" end-mill
©
Alex1N: Milling almost complete: for the time being...
©
Alex1N: All three holes drilled and tapped
©
Alex1N: Split nut pivot assembly fastened firmly in place
©
Alex1N: Another ("engaged") view of the split nut
©
Alex1N: Leadscrew dog-clutch mounting bracket
©
Alex1N: Lining up to drill the second mounting hole
©
Alex1N: Dog-clutch bracket installed
©
Alex1N: Tumbler/reverse assembly for the Jeffree leadscrew conversion for the TAIG microlathe
©
Alex1N: Top-side view of the leadscrew split-nut assembly
©
Alex1N: Parts for the leadscrew dog-clutch
©
Alex1N: A scattering of parts
©
Alex1N: Tumbler assembly from above, front
©
Alex1N: Tumbler assembly from above, rear
©
Alex1N: Close-up view of the tumbler lever and spring-lock
©
Alex1N: Sherline spindle handwheel with Jeffree adapter parts for the TAIG spindle
©
Alex1N: Dividing plate for the Jeffree Mk I dividing head
©
Alex1N: Rather blurry snap of the dividing disc
©
Alex1N: Two gears for the Jeffree fine-feed setup for his leadscrew attachment
©
Alex1N: I made a slight mistake when ordering these two large gears
©
Alex1N: Three TAIG lathe collets
©
Alex1N: Collet-closer (outer) ends of the collets
©
Alex1N: Jeffree Mk I dividing head after cleaning and reassembling
©
Alex1N: Rear side of the Mk I dividing head
©
Alex1N: Another almost identical snap of the dividing head
©
Alex1N: Dividing head seen from the cutting tools' viewpoint
©
Alex1N: Taig II lathe with the Jeffree Mk I dividing head sitting on the saddle cross-slide