©
Alex1N: The Schneider Electric Altivar ATV12 inverter's front plate
©
Alex1N: Grinder head
©
Alex1N: X- and Y-axis assembly in their saddle
©
Alex1N: One of my mill-table clamps
©
Alex1N: Clamps viewed from the other side
©
Alex1N: Starting to set up the roof panel installation
©
Alex1N: Getting ready to glue on the end-plate "feet"
©
Alex1N: "Worm's-eye" view of an eyebolt
©
Alex1N: Always test-fit!
©
Alex1N: Glue-voids dealt with
©
Alex1N: Always do a test fit!
©
Alex1N: Eight eye-bolt reinforcing pads
©
Alex1N: Slightly different exposure of previous view
©
Alex1N: Frame all glued up!
©
Alex1N: Another experiment
©
Alex1N: Support gusset gusset test fitted
©
Alex1N: One more set of things for the stern roof former
©
Alex1N: Long view of the two side-panels clamped together
©
Alex1N: The nearest frame locators are (more or less) in alignment
©
Alex1N: The holes were cut in both formers at the same time, of course
©
Alex1N: Six holes cut with one of the saws from my cheap spring-steel hole-saw set
©
Alex1N: Both end formers clamped together, face to face
©
Alex1N: Both formers glued
©
Alex1N: Array of clamps to be used in the glueing operation
©
Alex1N: Close-up of the filled butt-strap screw holes
©
Alex1N: Top and bottom sticks temporarily clamped in place
©
Alex1N: Temporary worktable
©
Alex1N: Five sheets of el cheapo 6 mm plywood clamped together
©
Alex1N: Starting notch for the jigsaw
©
Alex1N: Same view of cable rig, different exposure