©
Alex1N: Mill baseboard
©
Alex1N: Slightly better view of (one of) the form-ply stack's edges
©
Alex1N: Underside of the TAIG mill base
©
Alex1N: Mill base: 10 mm mild steel plate (undersurface)
©
Alex1N: Lower surface of steel base-plate coated with epoxy glue
©
Alex1N: Steel base-plate installed on the baseboard
©
Alex1N: Another view of the installed plate
©
Alex1N: V
©
Alex1N: Screw countersinks filled with epoxy glue
©
Alex1N: Excess glue used to fill in a "trench" in the baseboard
©
Alex1N: Another edge of the baseboard
©
Alex1N: Final edge-rounding finished on the mill's baseboard
©
Alex1N: Another view of shaped (left) edge
©
Alex1N: Close-up of one of the mill base-board's corners
©
Alex1N: Marking out and centre-pops for the new batch of locating holes
©
Alex1N: Three new bolt holes
©
Alex1N: Centralised and square mill base with repsect to base-board, more or less
©
Alex1N: All three bolts match the three holes in the mill base :)
©
Alex1N: Top surface of mill base-block flattened
©
Alex1N: Bottom surface of the mill-base: also sanded flat
©
Alex1N: Sanded mill base-block bottom surface
©
Alex1N: Mill base-block with epoxy filler around the top edges
©
Alex1N: Close-up of the glue filler-bead
©
Alex1N: Top and sides sanded
©
Alex1N: Long(-ish) Perma-Grit block used to rough-shape the edges
©
Alex1N: Initial corner removed (45 degrees)
©
Alex1N: Final rounding done with block and sandpaper
©
Alex1N: All done
©
Alex1N: More filling!
©
Alex1N: Some floor-space again - at last!