©
Alex1N: Electronic and mechanical parts for TAIG mill CNC conversion
©
Alex1N: TAIG manual mill on right, box o' CNC parts on left
©
Alex1N: TAIG mill from front on
©
Alex1N: Close-up of the box of CNC bits
©
Alex1N: How not to organise a lathe bench!
©
Alex1N: Close-up of the mess on the lathe bench
©
Alex1N: TAIG manual mill in use
©
Alex1N: Three change-gear bobbins with keyways milled
©
Alex1N: Milling the underside of the lathe saddle with a 3/8" end-mill
©
Alex1N: Split nut/pivot plate assembly sitting on its newly-milled seat
©
Alex1N: All three holes drilled and tapped
©
Alex1N: Split nut pivot assembly fastened firmly in place
©
Alex1N: Another ("engaged") view of the split nut
©
Alex1N: Leadscrew dog-clutch mounting bracket
©
Alex1N: Lining up to drill the second mounting hole
©
Alex1N: Dog-clutch bracket installed
©
Alex1N: Tumbler/reverse assembly for the Jeffree leadscrew conversion for the TAIG microlathe
©
Alex1N: Fixture plate for milling the "4th axis" feet under way
©
Alex1N: Eight holes
©
Alex1N: Jeffree 4th-axis/Mk 2 Dividing Head fixture plate almost complete
©
Alex1N: Headstock fixture plate attached
©
Alex1N: TAIG lathe headstock mounted upside down to check milling fixture
©
Alex1N: Top-side view of the leadscrew split-nut assembly
©
Alex1N: Lots of sawing of cast iron
©
Alex1N: Pieces of sawn cast iron
©
Alex1N: Recipient vices
©
Alex1N: Before...
©
Alex1N: During...
©
Alex1N: After...
©
Alex1N: Slightly closer-up view of the headstock's stumps