©
PaulWay: 1) The unaltered BMS cell board
©
PaulWay: 2) Put the terminal block in the vice
©
PaulWay: 3) Drill a hole in the end of the terminal block
©
PaulWay: 4) A hole in the end of the terminal block
©
PaulWay: 5) Stick a screwdriver part way into the hole
©
PaulWay: 6) Lever the red cap out of the terminal block
©
PaulWay: 7) The cap removed
©
PaulWay: 8) Open the splice plate up
©
PaulWay: 9) The wire removed from the splice
©
PaulWay: 10) Both wires stripped back
©
PaulWay: 11) Male and female spade connectors soldered on
©
PaulWay: 12) Apply to lots of cell modules
©
PaulWay: 13) Add heat-shrink around female spade connector