©
samotage: Coordinate errors from solder paste run
©
samotage: The y axis timing belt was too short!
©
samotage: Y axis motor mount was wobbly - this is beefy, and has z drive
©
samotage:
©
samotage: Whole back is re-inforced for the high mount z drive fixing.
©
samotage: Tilted for a little extra travel
©
samotage: Gusset to prevent x-axis bracket flex - with polyurethane glue
©
samotage: The other side gets a special gusseting to allow good home travel.
©
samotage: The webcam mount - the original one failed.
©
samotage: This is the mount for the solder paste syringe
©
samotage: PCB fiducials make an awesome home spot, also check spot for nozzle offset.
©
samotage:
©
samotage: Giving up on feed (for now) instead going to use fixed tapes and solve it with code.
©
samotage: New pick needle made from a piece of 1/4 inch all thread, 18gauge syringe needle and magic.
©
samotage:
©
samotage: 3 way solenoid valve with vent piping and home brew muffler.
©
samotage: Another view of the rear re-inforcement
©
samotage: This was a little tricky to fit...
©
samotage: Rails cut short for the gusset.