theflyingramen:
Initial clearance check w/ 12mm standoffs
theflyingramen:
Initial clearance check w/ 12mm standoffs
theflyingramen:
Decased spek sat and camera bracket placement
theflyingramen:
Running power wires to the AIO
theflyingramen:
Running Power Wires to AIO
theflyingramen:
Stripping the ESCs
theflyingramen:
Motor Wires Removed
theflyingramen:
Measure and cut
theflyingramen:
Testing motor/esc directions
theflyingramen:
All 4 ready
theflyingramen:
placements on the frame
theflyingramen:
powering up and testing Spektrum Sat RX
theflyingramen:
Direct solder to FC to clear topplate
theflyingramen:
Hot glue to hold wire in place and route wires around stock connectors
theflyingramen:
Test fitting VTX, only E8 as there's no room for dip switch
theflyingramen:
Custom made pin to sit flush against VTX
theflyingramen:
Custom made pin to sit flush against VTX
theflyingramen:
Custom made pin to sit flush against VTX
theflyingramen:
Camera & VTX test
theflyingramen:
Some filing of the servo connector required
theflyingramen:
It's tight in there.
theflyingramen:
Must glue on the side to keep slim profile
theflyingramen:
IMG_0631
theflyingramen:
Rechecking clearances
theflyingramen:
Placing of wires for the main harness
theflyingramen:
LC filter placement + short standoffs glued in for strength
theflyingramen:
placement / install of ESCs and motors
theflyingramen:
Test fit again + wire placement
theflyingramen:
really tight fit
theflyingramen:
IMG_0638
