ed.perello:
Making shore the two washers are in with the screw behind the red bushing.
ed.perello:
Insert the two magnets into blue housing.
ed.perello:
Insert the two magnets into blue housing.
ed.perello:
The larger slot is for the electronics.
ed.perello:
Make shore that the battery's are facing down in the larger section of the blue bushing.
ed.perello:
Make shore that the battery's are facing down in the larger section of the blue bushing.
ed.perello:
Make shore that the LED is centered.
ed.perello:
You may want to put a little lubricant like petroleum jelly on the outer blue housing to make it easier to move around.
ed.perello:
Making sure the led go's through the hole in the steel housing on the back side.
ed.perello:
You may want to put a little lubricant like petroleum jelly on the outer blue housing to make it easier to move around.
ed.perello:
Put in white ring. And turn slowly till you see the small holes. Line them up.
ed.perello:
Line up holes for final assembly . Then gently push it in. Making shore that the LED can go through the hole in the back of the steel housing.
ed.perello:
Take off white ring.
ed.perello:
Teethe side down on copper threaded ring.
ed.perello:
Add spring.
ed.perello:
Add white ring. Line up holes. Then put in small set screws.
ed.perello:
Then put in small set screws.
ed.perello:
Then put in small set screws.
ed.perello:
Then put in the last set screw.
