Daniel Sikar:
Filament trays I
Daniel Sikar:
Filament trays II
Daniel Sikar:
Working area
Daniel Sikar:
Drill presses
Daniel Sikar:
Orca black frame II
Daniel Sikar:
Orca black frame I
Daniel Sikar:
Bottom assembly
Daniel Sikar:
Orca frame bottom
Daniel Sikar:
Orca frame top
Daniel Sikar:
Threaded rods, nuts and washers
Daniel Sikar:
Frame being assembled
Daniel Sikar:
Pietr putting his frame together
Daniel Sikar:
Pietr working it out
Daniel Sikar:
My frame
Daniel Sikar:
Orca frame, adding z pulley
Daniel Sikar:
Inserting nut into stepper pulley
Daniel Sikar:
Lunch trolley
Daniel Sikar:
Stepper motor pre-assembly
Daniel Sikar:
Stepper motors
Daniel Sikar:
PLA trays
Daniel Sikar:
Y-side right pre-assembly
Daniel Sikar:
Mark from water jet cutting
Daniel Sikar:
Y-Side Right Pre-Assembly
Daniel Sikar:
Printing more Orcas
Daniel Sikar:
Parts
Daniel Sikar:
Blue Orca frame
Daniel Sikar:
RepRaps under my desk
Daniel Sikar:
Next generation Orca plug and play thermistor and resistor
Daniel Sikar:
Heater blocks
Daniel Sikar:
6 ohm resistor, for the heater block, part of the extruder
